Manual | Xycd60

Max 10A (though 8A is recommended for long-term stability).

If OP is set, the relay will automatically disconnect after the specified duration, even if the voltage threshold hasn't been reached. This acts as a safety backup.

This mode is used to protect batteries from deep discharge. The module connects the load when the battery is full and disconnects it once the voltage hits a minimum threshold. Voltage ≥is greater than or equal to UP . Condition to Stop: Voltage ≤is less than or equal to dn . Setting Up the XY-CD60 Entering Setup xycd60 manual

The XY-CD60 acts as a programmable voltage-controlled switch. It does not provide power itself; rather, it controls an onboard relay to connect or disconnect a power source (for charging) or a load (for discharging) based on voltage thresholds you define. Voltage Range: DC 6V–60V.

Long press the DOWN button to toggle the backlight sleep mode. "On" keeps the light on; "OFF" turns the light off after 5–10 minutes of inactivity. Safety Precautions Max 10A (though 8A is recommended for long-term stability)

for about 3 seconds to enter the parameter setting interface. Short press SET to cycle through the parameters: UP : Upper limit voltage. dn : Lower limit voltage. OP : Conduction time (00:00 to 99:59, or "----" to disable). dOP : Delayed conduction time (0–999 seconds). FOP : Forced start time (0–10 seconds) in discharge mode. Use UP/DOWN buttons to adjust the values. Press and hold SET again to save and exit. Voltage Percentage Calculation

Percentage=Current Voltage−dnUP−dn×100%Percentage equals the fraction with numerator Current Voltage minus dn and denominator UP minus dn end-fraction cross 100 % This mode is used to protect batteries from deep discharge

The module calculates the battery percentage using the formula:

Avoid running continuous loads right at the 10A limit to prevent the relay from overheating.